ESP
Loader is fine and status is green, but ESP is not showing in Crucible. Overlay is there. Boxes and skeletons are empty on Midtown and Javelin-4.
I already closed Discord overlay once. What else should I check before I open a ticket?
9 Replies
- adept_farm
Classic first-launch thing. Overlay drawing but no boxes usually means the DMA layer is not fully up. Did you enable HVCI, TPM and Secure Boot in BIOS?
- season_pass OP
Windows shows Core Isolation on. I have not actually gone into BIOS though.
- adept_farm
That is the trap — Windows can say on while firmware is off. Turn it on in BIOS itself, then reboot.
- d2cheats_staff Staff ✓ Solution
Empty ESP on a green status is almost always Cloud DMA requirements. Enable HVCI, TPM and Secure Boot in BIOS, reboot, then launch in the order on the Setup page. Cloud DMA is required for the full feature set.
- flawless_card
Also kill other overlays while you test — RTSS, GeForce, Discord. They can fight the stream-proof layer on first run.
- season_pass OP
Secure Boot was off in BIOS even though Windows said on. Enabled it, rebooted, boxes are drawing now on Midtown.
- adept_farm
Every time. Glad it was that and not a patch.
- kings_fall
For future — if ESP ever goes empty after a game update, check Updates first. Empty boxes on a yellow day is the build, not your setup.
- d2cheats_staff Staff
Right. If it is green and still empty after the BIOS steps, open a Support ticket with your order ID and we will walk it live.
This thread is closed.
Replies were disabled after the discussion wrapped up. For account or license
questions, contact Support.